No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for VLANs

Default Settings for VLANs

Table 4-8  Default setting for VLANs


Default Setting

Default configuration of an interface

Interface type


Default VLAN


VLAN that an interface joins
  • VLAN 1 that access interfaces join in untagged mode (port default vlan 1)
  • VLANs 1 to 4094 that trunk interfaces join in tagged mode (port trunk allow-pass vlan 1 to 4094)

Damping time for a VLANIF interface in Down state


Traffic statistics collection in a VLAN


Traffic statistics collection on a VLANIF interface


Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 107524

Downloads: 71

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next