No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling HVRP Globally

Enabling HVRP Globally

Context

Through dynamic VLAN registration and aging mechanisms, HVRP ages the VLANs that do not forward packets on interfaces and saves only necessary VLANs. When a VLAN contains at most two interfaces, the interfaces do not learn MAC addresses, data packets are broadcast in the VLAN and no extra bandwidth is consumed.

NOTE:
  • When STP works in VBST mode, do not enable HVRP. When HVRP is enabled, do not change the working mode of STP to VBST.
  • When the VCMP role is the client or server, HVRP cannot be enabled. In this case, run the vcmp role command to configure the VCMP role as silent or transparent. If HVRP has been enabled, do not switch the VCMP role to client or server.
  • After HVRP is enabled, the switch dynamically sets the MAC address learning mode for the VLAN. Therefore, you do not need to set the maximum number of MAC addresses that can be learned in the VLAN.

  • HVRP and GVRP cannot be enabled simultaneously.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run hvrp enable

    HVRP is enabled globally.

    By default, HVRP is disabled globally.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95858

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next