No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Does a Switch Process BPDUs?

How Does a Switch Process BPDUs?

By default, an interface discards the received BPDUs. To configure an interface to forward BPDUs, run the bpdu bridge enable command.

If a protocol is enabled on an interface, BPDUs of the protocol are sent to the CPU for processing. For example, if only STP is enabled on an interface, STP BPDUs are sent to the CPU for processing regardless of whether the bpdu bridge enable or bpdu bridge disable command is run. BPDUs of other protocols are discarded.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 117371

Downloads: 73

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next