No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Public User Services on a Metro Ethernet Network

Public User Services on a Metro Ethernet Network

Figure 10-7  QinQ application on a metro Ethernet network

In Figure 10-7, the digital subscriber line access multiplexers (DSLAMs) support multiple permanent virtual channels (PVCs). This allows each user to use multiple services such as High-Speed Internet (HSI), Internet Protocol Television (IPTV), and voice over IP (VoIP).

The carrier assigns different PVCs and VLAN ranges to HSI, IPTV, and VoIP services, as listed in Table 10-5.

Table 10-5  Example of VLAN assignment

Service

VLAN Range

HSI

101 to 300

VoIP

301 to 500

IPTV

501 to 700

In VoIP communication, when a VoIP packet reaches a DSLAM through a specified PVC, the DSLAM marks the packet with a VLAN in the VLAN range mapped to the PVC (for example, 301). When the VoIP packet reaches the UPE, the UPE tags the packet with an outer VLAN ID mapping the VoIP VLAN ID range (for example, 2000). The inner VLAN ID represents user information, whereas the outer VLAN ID represents service information and the location of the DSLAM (packets from different DSLAMs are tagged with different outer VLAN IDs). When the packet reaches the NPE indicated by the outer VLAN tag, the VLAN tag is terminated on the QinQ termination sub-interface. The packet is then forwarded on the IP network or enters the corresponding VPN according to the core network configuration.

HSI and IPTV service packets are processed in the same manner, except that VLAN tags of HSI service packets are terminated on a broadband remote access server (BRAS).

The NPE can perform HQoS scheduling based on double tags and generate a DHCP binding table to avoid network attacks. In addition, the NPE can implement DHCP authentication based on double tags and other information. You can also configure VRRP on QinQ termination sub-interfaces to ensure service reliability.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 116571

Downloads: 73

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next