No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Recovery Time of an Interface

(Optional) Setting the Recovery Time of an Interface

Context

An LBDT-enabled interface periodically sends LBDT packets to detect loops. After a loop is detected, an action configured by the loopback-detect action command is taken on the interface. In addition, the system counts the time. After the configured recovery time expires, the system attempts to restore the problematic interface. If the device does not receive detection packets from the problematic interface within the next recovery time, it considers that the loop is eliminated on the interface and restores the interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run loopback-detect recovery-time recovery-time

    The interface recovery time after a loop is removed is set.

    By default, the interface recovery time is three times the interval for sending LBDT packets.

    NOTE:

    It is recommended that the interface recovery time be three times the packet sending interval at least. If the packet sending interval has been set to a small value, the interface recovery time should be at least 10 seconds longer than the packet sending interval.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 107598

Downloads: 71

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next