No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Link Type of a Port

Setting the Link Type of a Port

Context

It is easy to implement rapid convergence on a P2P link. If the two ports connected to a P2P link are root or designated ports, the ports can transit to the forwarding state quickly by sending Proposal and Agreement packets. This reduces the forwarding delay.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the Ethernet interface participating in STP calculation is displayed.

  3. Run stp point-to-point { auto | force-false | force-true }

    The link type is configured for the interface.

    By default, an interface automatically determines whether to connect to a P2P link. The P2P link supports rapid network convergence.

    • If the Ethernet port works in full-duplex mode, it is connected to a P2P link. In this case, specify force-true to implement rapid network convergence.

    • If the Ethernet port works in half-duplex mode, specify force-true to forcibly set the link type to P2P.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95258

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next