No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring ERPS Protection Switching

(Optional) Configuring ERPS Protection Switching

Context

To ensure that ERPS rings function normally when a node or link fails, configure revertive/non-revertive switching, port blocking mode, and timers.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run erps ring ring-id

    The ERPS ring view is displayed.

  3. Run revertive { enable | disable }

    The protection switching mode is specified.

    By default, ERPS rings use revertive switching.

  4. Run quit

    Return to the system view.

  5. Run interface interface-type interface-number

    The interface view is displayed.

  6. Run erps ring ring-id protect-switch { force | manual }

    A port blocking mode is specified.

    The ERPS ring specified by ring ring-id must be the one to which the port belongs.

    To delete the specified port blocking mode, run the clear command in the ERPS ring view.

  7. Run quit

    Return to the system view.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 107260

Downloads: 71

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next