No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switching to the RSTP Mode

Switching to the RSTP Mode

Context

If an interface on an RSTP-enabled device is connected to an STP-enabled device, the interface switches to the STP compatible mode.

If the STP-enabled device is powered off or disconnected from the RSTP-enabled device, or the STP-enabled device is switched to the RSTP mode, the interface does not automatically switch back to the RSTP mode. In any of these cases, run the stp mcheck command to switch the interface to the RSTP mode.

Procedure

  • Switch to the RSTP mode in the interface view.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of an interface participating in spanning tree calculation is displayed.

    3. Run stp mcheck

      The interface is switched to the RSTP mode.

  • Switch to the RSTP mode in the system view.
    1. Run system-view

      The system view is displayed.

    2. Run stp mcheck

      The device is switched to the RSTP mode.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 108922

Downloads: 72

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next