No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the LACP Interface Priority

(Optional) Setting the LACP Interface Priority

Context

In LACP mode, LACP interface priorities are set to prioritize interfaces of the same device. Interfaces with higher priorities are selected as active interfaces.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The member interface view is displayed.

  3. Run lacp priority priority

    The LACP priority of the member interface is configured.

    By default, the LACP interface priority is 32768. In priority comparisons, numerically lower values have higher priority.

    By default, the system selects active interfaces based on interface priorities. This may lead to low-speed member interfaces with high priorities being selected as active interfaces, providing less bandwidth for services. To select high-speed member interfaces as active interfaces, run the lacp selected { priority | speed } command to configure the system to select active interfaces based on the interface rate.

    NOTE:
    If the max active-linknumber link-number command is run in the Eth-Trunk interface view, you need to run the lacp preempt enable command to enable LACP preemption on the current Eth-Trunk interface. Otherwise, interfaces with high LACP interface priorities may fail to be selected as active interfaces.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95028

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next