No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Service

CloudEngine 12800 and 12800E V200R005C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for ARP

Default Settings for ARP

Table 2-4 describes the default settings for ARP.

Table 2-4 Default settings for ARP


Default Setting

Aging time of dynamic ARP entries

1200 seconds

Maximum number of probes for aging dynamic ARP entries

3 times

Interval for sending ARP aging probe packets

5 seconds

Aging detection mode of dynamic ARP entries

An interface sends the last ARP Aging probe packet in broadcast mode, and the rest ARP Aging probe packets are sent in unicast mode.

ARP proxy

ARP proxy is disabled.

Updated: 2019-04-18

Document ID: EDOC1100039535

Views: 40346

Downloads: 25

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next