No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Service

CloudEngine 12800 and 12800E V200R005C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting the IPv6 Address Pool Status

Resetting the IPv6 Address Pool Status


If an IPv6 address conflict occurs because two clients are assigned the same IPv6 address or if new IPv6 addresses need to be assigned to clients due to network planning, you can set the IPv6 address pool to idle so that clients can re-apply for these IPv6 addresses.

After the reset dhcpv6 pool command is run, a user may be disconnected if the used IPv6 address is within the address range specified in this command.


  • Run reset dhcpv6 pool pool-name [ binding [ duid ] | { allocated | conflict } address | ipv6-address [ to ipv6-address ] ]

    The configured IPv6 address pool is cleared.

Updated: 2019-04-18

Document ID: EDOC1100039535

Views: 48314

Downloads: 27

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next