No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

CloudEngine 12800 and 12800E V200R005C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IPv6 over IPv4 Tunnel

Configuring an IPv6 over IPv4 Tunnel

You can configure IPv6 over IPv4 tunnels to interconnect IPv6 islands separated by IPv4 networks.

Pre-configuration Tasks

Before configuring an IPv6 over IPv4 tunnel, complete the following tasks:

  • Configuring the IPv4/IPv6 dual stack

    NOTE:
    Configure IP addresses on the source and destination ends of the tunnel to configure the IPv4/IPv6 dual stack.
  • Configuring a routing protocol to ensure that there are reachable IPv4 routes between the source and destination ends of the tunnel

Configuration Procedure

You can perform the following configuration tasks in any sequence and select one tunnel to configure.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1100039535

Views: 38840

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next