No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing IGMP Snooping Over VXLAN Entries

Clearing IGMP Snooping Over VXLAN Entries

Context

IGMP snooping over VXLAN entries are classified into static and dynamic entries, and they are cleared in different ways.

Static entries cannot be restored after being cleared and can be created when you configure static member ports.

When dynamic entries in a forwarding table are cleared, the hosts in the BD do not receive the multicast packets temporarily. The hosts in the BD receive the multicast packets again only after the hosts send IGMP Report messages and the forwarding entries are regenerated on the switch.

Procedure

  • Run the undo igmp snooping static-group [ source-address source-ip-address ] group-address { group-ip-address | all } [ dot1q vid vid | qinq pe-vid pe-vid ce-vid ce-vid ] command in the Layer 2 sub-interface view to remove the Layer 2 sub-interface from a multicast group.
  • Run the reset igmp snooping group { all | bridge-domain { all | bd-id } } command in the user view to remove dynamic entries in a forwarding table.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 46758

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next