No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the Trap Function for a Specified Module

Enabling the Trap Function for a Specified Module


On a multicast device managed by the network management system (NMS), you can enable the trap function for a specified module to monitor events of the specified protocol.


  1. Run system-view

    The system view is displayed.

  2. You can choose one or multiple operations to perform:

    • Run the snmp-agent trap enable feature-name msdp [ trap-name { establish | backward } ] command to enable the Multicast Source Discovery Protocol (MSDP) trap function.

      By default, the MSDP trap function is disabled.

    • Run the snmp-agent trap enable feature-name pim [ trap-name { interface-election | invalid-join-prune | invalid-register | neighbor-loss | new-neighbor | rp-mapping-change } ] command to enable the trap function for PIM.

      By default, the trap function is disabled for PIM.

    • Run the snmp-agent trap enable feature-name pim-std [ trap-name { pimneighborloss | piminvalidregister | piminvalidjoinprune | pimrpmappingchange | piminterfaceelection } ] command to enable the public PIM trap function.

      By default, the public PIM trap function is disabled.

  3. Run commit

    The configuration is committed.

Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 49240

Downloads: 87

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next