No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling Users from Dynamically Joining Multicast Groups

(Optional) Disabling Users from Dynamically Joining Multicast Groups

Context

If an upstream Layer 3 multicast device is a non-Huawei device and has static multicast groups configured on the user-side interface, multicast users are not allowed to dynamically join or leave multicast groups. In this case, disable the switch from sending IGMP Report and Leave messages carrying static group addresses to the upstream device.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run igmp snooping static-group suppress-dynamic-join

    The switch is disabled from sending IGMP Report and Leave messages that contain static group addresses to the upstream device.

    By default, the switch forwards IGMP Report and Leave messages that contain static group addresses to the router port.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 49526

Downloads: 87

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next