No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an RP

Configuring an RP

Context

In the anycast rendezvous point (RP) application, configure RPs with the same address on multiple switches in a PIM-SM domain. Before configuring anycast RP on the devices in the PIM-SM domain, configure a loopback interface on each device and assign the same IP address to the loopback interfaces. Then configure these interfaces as static RPs or candidate rendezvous points (C-RPs).

  • If you configure a static RP, configure an RP on each switch in the PIM-SM domain.
  • If you configure a dynamic RP, you only need to configure the dynamic RP on the switch as the anycast RP.
NOTE:

After an RP is configured, advertise the IP address of the RP interface through unicast routes to ensure that each switch on the network has a reachable route to the RP interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface loopback interface-number

    The loopback interface view is displayed.

  3. Run ip address ip-address { mask | mask-length }

    An IP address is configured for the loopback interface.

  4. (For a dynamic RP) Run pim sm

    PIM-SM is enabled on the RP interface.

    Before configuring a dynamic RP, run this command. This command is not required if you configure a static RP.

  5. Run quit

    Return to the system view.

  6. Run pim [ vpn-instance vpn-instance-name ]

    The PIM view is displayed.

  7. Configure the loopback interface address as a static RP address or a C-RP address.

    • Configure a static RP.

      Run static-rp rp-address

      The loopback interface address is configured as a static RP address.

    • Configure a dynamic RP.

      NOTE:

      When configuring dynamic RP, configure candidate bootstrap routers (C-BSRs). When configuring MSDP-based anycast RP, ensure that the addresses of the C-BSR and the C-RP are different. For details on how to configure the C-BSR, see Configuring a C-BSR.

      Run c-rp loopback interface-number

      The loopback interface address is configured as a C-RP address.

  8. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 46983

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next