No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the IPv4 Bidir-PIM Running Status

Monitoring the IPv4 Bidir-PIM Running Status

Context

During routine maintenance, you can run the following commands in any view to check the PIM running status.

Procedure

  • Run the display pim claimed-route [ source-address ] command to check unicast routing information used for PIM.
  • Run the display pim bfd session [ interface interface-type interface-number | neighbor neighbor-address ] * command to check information about PIM BFD sessions.
  • Run the display pim bsr-info command to check the BSR configuration.
  • Run the display pim control-message counters [ message-type { assert | hello | join-prune | bsr | backoff | offer | pass | win } | interface interface-type interface-number ] * command to check the statistics about PIM control messages sent and received by a PIM device.
  • Run the display pim interface [ interface-type interface-number | up | down ] [ verbose ] command to check PIM information on interfaces.
  • Run the display pim neighbor [ neighbor-address | interface interface-type interface-number | verbose ] * command to check information about PIM neighbors.
  • Run either of the following commands to check PIM routing information:

    • display pim routing-table [ group-address [ mask { group-mask-length | group-mask } ] ] { rpf-interface interface-type interface-number | mode bidir } * [ outgoing-interface { include | exclude | match } { interface-type interface-number | none } | flags flag-value | fsm ] * [ outgoing-interface-number [ number ] ]
    • display pim routing-table brief [ group-address [ mask { group-mask-length | group-mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-interface { interface-type interface-number | register } ] *

  • Run the display pim rp-info [ group-address ] command to check information about RPs for a multicast group.
  • Run the display pim invalid-packet [ interface interface-type interface-number | message-type { assert | bsr | hello | join-prune | offer | backoff | win | pass } ] * command to check the statistics about invalid PIM control messages received by a PIM device.
  • Run the display pim df-info [ rp rp-address | interface interface-type interface-number | verbose ] * command to check information about DFs for an RP.
  • Run the display multicast global { pim sm | pim dm | bidir-pim | all } statistics command to check PIM entry restriction and statistics.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 47274

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next