No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling IGMP Snooping

Enabling IGMP Snooping

Context

Other IGMP snooping functions can be configured only after IGMP snooping is enabled globally. Other IGMP snooping functions take effect in a VLAN only after IGMP snooping is enabled in the VLAN.

By default, IGMP snooping is disabled globally on the switch.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run igmp snooping enable

    IGMP snooping is enabled globally.

  3. Run vlan vlan-id

    The VLAN view is displayed.

  4. (Optional) Run multicast layer-2 forwarding-mode { ip | mac }

    The multicast forwarding mode in the VLAN is set to IP address-based or MAC address-based forwarding.

    By default, the CE6810LI forwards multicast flows based on MAC addresses, and the other models forward multicast flows based on IP addresses.

    NOTE:
    • On the CE6810LI, the default multicast forwarding mode cannot be changed using this command.
    • Configure the multicast forwarding mode in a VLAN before IGMP snooping is enabled in the VLAN. Then enable IGMP snooping in the VLAN for the configuration to take effect.

    • If the device forwards multicast data packets based on MAC addresses, do not use a group address on the network if the group address maps to the same multicast MAC address as a multicast IP address reserved for a protocol. Otherwise, the protocol that uses the multicast IP address cannot run normally. For example, Open Shortest Path First (OSPF) uses 224.0.0.5 to send protocol packets. This multicast IP address maps to multicast MAC address 01-00-5E-00-00-05. If multicast data packets are forwarded based on MAC addresses and use multicast IP address 225.0.0.5 (also mapping to 01-00-5E-00-00-05), the OSPF protocol cannot run normally.

    • If the VLAN is configured as a customer edge (CE) VLAN of Transparent Interconnection of Lots of Links (TRILL) and enabled with IGMP snooping, the multicast packets in the VLAN are forwarded based on MAC addresses, and the forwarding mode cannot be changed.

  5. Run igmp snooping enable

    IGMP snooping is enabled in the VLAN.

    Run the igmp snooping enable [ vlan { vlan-id1 [ to vlan-id2 ] } &<1-10> ] command in the system view to enable IGMP snooping in multiple VLANs.

  6. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 47519

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next