No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of MLD Configuration Tasks

Summary of MLD Configuration Tasks

Table 3-5 lists MLD configuration tasks.

Table 3-5 MLD configuration tasks

Task

Description

Configuring Basic MLD Functions

To enable receiver hosts to join an IPv6 multicast network and receive multicast data, you must configure basic MLD functions on the switch interface connected to the receiver hosts.

Optimizing MLD Performance

After basic MLD functions are configured on the multicast switch, the switch can exchange MLD messages with member hosts to maintain group membership with the default configurations. You can optimize MLD performance on the switch according to requirements of network security and performance optimization.

Configuring MLD SSM Mapping

The SSM model allows MLDv2 hosts to specify the multicast sources from which they want to receive data. In some cases, receiver hosts can run only MLDv1. To allow these hosts to use SSM, configure MLD SSM mapping on the switch to provide the SSM service for MLDv1 receiver hosts.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 47270

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next