No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring IPv6 Multicast Routing and Forwarding

Monitoring IPv6 Multicast Routing and Forwarding

Context

During routine maintenance, run the following commands in any view to check the running status of the IPv6 multicast forwarding and routing tables.

Procedure

  • Run the display multicast ipv6 boundary [ ipv6-group-address [ ipv6-group-mask-length ] ] [ interface interface-type interface-number ] command to check information about the IPv6 multicast boundary configured on an interface.
  • Run the display multicast ipv6 fib [ source ipv6-source-address | group ipv6-group-address | incoming-interface { interface-type interface-number | register } ] * command to check the IPv6 multicast forwarding table.
  • Run the display multicast ipv6 routing-table [ ipv6-source-address [ mask ipv6-source-mask-length ] | ipv6-group-address [ mask ipv6-group-mask-length ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { { exclude | include | match } { interface-type interface-number | register | none } } ] * [ outgoing-interface-number [ number ] ] command to check the IPv6 multicast routing table.
  • Run the display multicast ipv6 rpf-info ipv6-source-address [ ipv6-group-address ] [ rpt | spt ] [ verbose ] command to check the Reverse Path Forwarding (RPF) route.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 47465

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next