No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling Software Forwarding for IPv6 Multicast Packets

Disabling Software Forwarding for IPv6 Multicast Packets

Pre-configuration Tasks

Before disabling soft forwarding for IPv6 multicast packets, complete the following tasks:

  • Configure an IPv6 unicast routing protocol to ensure normal unicast routing on the IPv6 network.
  • Run the multicast ipv6 routing-enable command in the system view to enable Layer 3 IPv6 multicast routing globally.

Context

In most cases, the switch performs software forwarding before the hardware forwarding entries are generated. After hardware forwarding entries are generated, the switch performs hardware forwarding.

Soft forwarding for IPv6 multicast packets must be disabled on the switch to prevent the low forwarding speed and first packet cache mechanism of soft forwarding from causing disorder of the first packet transmitted at a high speed.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 cpu-forward disable

    Software forwarding is disabled for IPv6 multicast packets.

    By default, software forwarding for IPv6 multicast packets is enabled.

    In the scenario where Fast Channel Change (FCC) is enabled, it is recommended that you use the multicast ipv6 cpu-forward disable command to disable soft forwarding for IPv6 multicast packets.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039595

Views: 47421

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next