RM/2/hwL3vpnIpv6PrefixExceed_active
Message
RM/2/hwL3vpnIpv6PrefixExceed_active:The number of IPv6 prefixes in the VPN instance exceeded the maximum value. (VpnInstanceName=[VpnInstanceName], PrefixCount=[VpnInstanceRouteCount], MaxValue=[MaxValue])
Description
The number of IPv6 route prefixes in a VPN instance exceeded the maximum number that is allowed.
Parameters
Parameter Name | Parameter Meaning |
---|---|
VpnInstanceName |
Name of a VPN instance |
PrefixCount |
Current number of IPv6 route prefixes in the VPN instance |
MaxValue |
Maximum number of IPv6 route prefixes in the VPN instance |
Possible Causes
Cause 1:
A large number of IPv6 routes were added to the routing table in the VPN instance.
Cause 2:
The maximum number of IPv6 route prefixes in the VPN instance was reduced.
Procedure
- Run the display ipv6 routing-table vpn-instance vpn-instance-name statistics command to check the total number of IPv6 route prefixes in the VPN instance and the number of routes of each routing protocol that are added to the IPv6 routing table in the VPN instance. Then, run the display ipv6 routing-table limit command to check whether the number of IPv6 route prefixes in the VPN instance exceeds the configured maximum number.
- Delete unneeded IPv6 VPN routes or run the ipv6 prefix-limit number { alert-percent [ route-unchanged ] | simply-alert } command to increase the maximum number. Then, check whether the alarm persists.
- Collect trap, log, and configuration information, and contact technical support personnel technical support personnel.
- End.