DEVM/3/hwRemoteFaultAlarm_active
Message
DEVM/3/hwRemoteFaultAlarm_active: The remote fault alarm has occurred. (IfIndex=[hwPhysicalPortIfIndex], IfName=[hwPhysicalPortName])
Parameters
Parameter Name | Parameter Meaning |
---|---|
hwPhysicalPortIfIndex |
Physical interface index. |
hwPhysicalPortName |
Physical interface name. |
Possible Causes
Because the link from the local interface to the remote interface was faulty, for example, the transmit optical fiber was removed from the local interface, the remote interface could not receive packets sent from the local interface. In this case, the local interface reported this alarm.
Procedure
- Check whether the transmit optical fiber fails.
- If so, replace the optical fiber.
- If not, go to step 2.
- Check whether the optical module on the local or remote interface fails.
- If so, replace the optical module.
- If not, go to step 3.
- Check whether a card on the local or remote device fails.
- If so, replace the card.
- If not, go to step 4.
- Collect alarm, log, and configuration information, and contact technical support personnel.