Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DRIVER/5/SYSMACCHANGE
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| CurMac | Indicates the current stack MAC address. |
| PreMac | Indicates the stack MAC address before the switchover. |
Possible Causes
After the stack MAC address switchover is configured, the MAC address changes when the stack splits or a member device leaves the stack.
Procedure
- Run the display system mac-address command to check
whether the stack MAC address switchover is configured.
If so, go to Step 2.
If not, go to Step 3.
- Check whether an active/standby switchover occurs or a member device leaves the stack.
- This log message is informational only, and no action is required.
Previous
