Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OVSDB_CLIENT/3/hwOvsdbCfgFailureEvent
Message
OVSDB_CLIENT/3/hwOvsdbCfgFailureEvent: Failed to deliver OVSDB configurations.(Reason=[Reason], Detail=[Detail])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
Reason |
Reason why the OVSDB client fails to deliver the configuration. |
Detail |
Detailed information about the configuration. |
Possible Causes
- Cause 1: Failed to create interface-name because main-interface has been added to an Eth-Trunk.
- Cause 2: The number of BDs exceeds the upper limit (8000).
- Cause 3: The BD to which the Layer 2 sub-interface is added does not exist.
- Cause 4: interface-name does not exist.
- Cause 5: The BFD session exists.
- Cause 6: Another encapsulation type has been configured on interface-name.
- Cause 7: The VLAN has been used by the main interface.
Procedure
- Cause 1: Failed to create interface-name because main-interface has been added to an Eth-Trunk.
- Run the undo eth-trunk command in the interface view to remove the main interface from the Eth-Trunk.
- Use another interface as the Layer 2 sub-interface. You can run the display interface brief command to view the physical interface that has been added to the Eth-Trunk.
- Cause 2: The number of BDs exceeds the upper limit (8000).
- Cause 3: The BD to which the Layer 2 sub-interface is added does not exist.
When a Layer 2 sub-interface is added to a BD, the BD does not exist. In this case, the VMware NSX controller fails to create a BD, and you need to deliver the configuration again.
- Cause 4: interface-name does not exist.
The Layer 2 sub-interface does not exist. In this case, the VMware NSX controller fails to create a Layer 2 sub-interface, and you need to deliver the configuration again.
- Cause 5: The BFD session exists.
This problem does not affect service operation, and no action is required.
- Cause 6: Another encapsulation type has been configured on interface-name.
Delete the traffic type that has been configured on the Layer 2 sub-interface.
- Cause 7: The VLAN has been used by the main interface.
Previous
