Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ERPS/2/FWSTATEDISCARDING
Message
ERPS/2/FWSTATEDISCARDING: The state of ERPS port was changed to discarding. (RingId=[RingID], InterfaceIndex=[IfIndex], InterfaceName=[IfName])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| RingId | ERPS ring ID |
| InterfaceIndex | Port index |
| InterfaceName | Port name |
Possible Causes
Cause 1: A new link was added to the ERPS ring.
Cause 2: An ERPS ring port went Up or Down.
Procedure
- Check physical devices on the network to see whether a
new ERPS-enabled physical link is added.
If a new physical link has been added, go to Step 2.
If no new physical link has been added, go to Step 3.
- Check whether the added physical link is needed.
If the added physical link is needed, this trap message is informational only, and no action is required.
If the added physical link is not needed, go to Step 4.
- Check whether any port added to the ERPS ring goes Up or
Down.
If a port added to the ERPS ring has gone Up or Down, this trap message is informational only, and no action is required.
If no port added to the ERPS ring has gone Up or Down, go to Step 4.
- Collect trap, log, and configuration information, and contact technical support personnel.
Previous
