DRIVER/4/hwBoardBecomeMaster
Message
DRIVER/4/hwBoardBecomeMaster: Board changed to the master state. (EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityType=[EntityType], EntityTrapFaultID=[EntityTrapFaultID], Reason=Master/Slave Board Switchover.)
Parameters
Parameter Name | Parameter Meaning |
---|---|
EntityPhysicalIndex | Indicates the entity index. |
EntPhysicalIndex | Indicates the entity index. |
EntPhysicalName | Indicates the entity name. |
EntityType | Indicates the entity type. |
EntityTrapFaultID | Indicates the error code: 133120. |
Reason | Indicates a possible cause. |
Procedure
- Check whether active/standby switchover was performed.
If so, no action is required.
If not, go to step 2.
- Run the display device [ slot slot-id ] command to check whether the original active device has been registered successfully.
If so, go to step 4.
If not, go to step 3.
- Remove and install the original active device and check whether it has been
registered successfully after startup.
If so, go to step 4.
If not, go to step 5.
- Check whether the original active device is faulty. Run the slave
switchover command to check whether the active/standby switchover
can be performed.
If so, no more action is required.
If not, go to step 5.
- Collect traps, logs, and configurations, and contact technical support personnel.