Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DEVM/4/hwStackMacInconsistence_active
DEVM/4/hwStackMacInconsistence_active
Message
DEVM/4/hwStackMacInconsistence_active: The stack system's
MAC address is not the manufacture MAC address of any member device.(hwStackSystemMac=[hwStackSystemMac])
Description
After a stack splits, the stack system MAC address
is not the factory MAC address of any member device.
Parameters
Parameter Name
Parameter Meaning
hwStackSystemMac
Indicates the stack system MAC address.
Possible Causes
Cause 1: The configured stack system
MAC address is not the factory MAC address of any member device.
Cause 2: The stack system MAC address is not the
factory MAC address of any member device.
Procedure
Cause 1: The configured stack system MAC address
is not the factory MAC address of any member device.
Run the display system mac-address command in the
stack to check the configured stack system MAC address and factory
MAC addresses of all member devices.
If no MAC address conflict occurs, you can run the set
system mac-address inconsistence-alarmoff command in the stack management view to disable
the alarm function.
If a MAC address conflict occurs, you can run the undo set system mac-address command in the stack management view to delete the configured
stack system MAC address and then run the set system
mac-address switch-delayimmediately command to change the stack system MAC address to the MAC address
of the current master switch.
Cause 2: The stack system MAC address is not
the factory MAC address of any member device.
Run the display system mac-address command in the
stack to check the stack system MAC address and factory MAC addresses
of all member devices.
If no MAC address conflict occurs, you can run the set
system mac-address inconsistence-alarmoff command in the stack management view to disable
the alarm function.
If a MAC address conflict occurs, you can run the set system
mac-address switch-delayimmediately command to change the stack system MAC address to the MAC address
of the current master switch.
Previous
