Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PIM/4/CRT_L3ENTRY_FAIL
Message
PIM/4/CRT_L3ENTRY_FAIL:In the VPN instance, PIM failed to create entry in the multicast routing table. (VPNName=[VPNName], GrpAddr=[GrpAddr], SrcAddr=[SrcAddr], Reason=[Reason])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
VPNName |
VPN instance name |
GrpAddr |
Group address
|
SrcAddr |
Source address
|
Reason |
Reason of PIM entry creating failure |
Possible Causes
Cause 1: The multicast source was filtered out.
Cause 2: A multicast forwarding boundary was set.
Cause 3: The RP address was wrong.
Cause 4: The upstream interface could not be found.
Cause 5: The multicast group was in the range of SSM group addresses.
Cause 6: The memory was not enough.
Procedure
- Cause 1: The multicast source was filtered out.
- Cause 2: A multicast forwarding boundary was set.
- Cause 3: The RP address was wrong.
- Cause 4: The upstream interface could not be found.
- Cause 5: The multicast group was in the range of SSM group
addresses.
- Cause 6: The memory was not enough.
Previous
