PIM/4/CRT_SG_FAIL

Enterprise

Worldwide

Huawei Global - English

- South Africa - English
- Morocco - English
- Brazil - Português
- Mexico - Español
- United Arab Emirates - English
- Saudi Arabia - English
- Australia - English
- China - 简体中文
- Hong Kong, China - English
- India - English
- Japan - 日本語
- South Korea- English
- Kazakhstan - русский
- Malaysia - English
- Singapore - English
- Indonesia - English
- Thailand - English
- Philippines - English
- Austria - Deutsch
- Czech - English
- France - Français
- Germany - Deutsch
- Greece - English
- Hungary- English
- Italy - Italiano
- Poland - English
- Sweden - English
- Russia - русский
- Spain - Español
- Turkey - Türkçe
- United Kingdom - English
- Ukraine - English

Menu
Products and Services
Industries
Technical Support
Partners
Community

Most people search for
Switches Routers Servers Storage Data Center Energy Cloud Computing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00 Log Reference

This document provides the explanations, causes, and recommended actions of logs on the product.

Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).

PIM/4/CRT_SG_FAIL

Message

PIM/4/CRT_SG_FAIL:In the VPN instance, PIM-SSM failed to create the (S,G) entry in the multicast routing table. (VPNName=[VPNName], GrpAddr=[GrpAddr], SrcAddr=[SrcAddr])

Description

Failed to create the (S, G) entry.

Parameters

Parameter Name	Parameter Meaning
VPNName	Indicates the name of a VPN instance.
GrpAddr	Indicates the group address.
SrcAddr	Indicates the source address.

Possible Causes

Cause 1: The multicast source was filtered out.

Cause 2: The memory was not enough.

Cause 3: The current route entries reached the upper limit.

Procedure

Cause 1: The multicast source was filtered out.
1. Run the display acl { acl-number | name acl-name | all } command to ensure the (S, G) will not be filtered out, that is, ensure that the source address and group address will not be denied by the ACL applied to multicast.
  - If the fault is rectified, proceed to Step 3.
  - If the fault persists, proceed to Step 2.
2. Collect log messages and contact technical support personnel.
3. End.
Cause 2: The memory was not enough.
1. Ensure that system memory is enough.
  - If the fault is rectified, proceed to Step 3.
  - If the fault persists, proceed to Step 2.
2. Collect log messages and contact technical support personnel.
3. End.
Cause 3: The current route entries reached the upper limit.
1. Run the display pim routing-table and display multicast routing-table commands to check the total number of PIM entries and multicast routing entries. Ensure that the total number does not reach the upper limit specified in the current PIM version.
  - If the fault is rectified, proceed to Step 3.
  - If the fault persists, proceed to Step 2.
2. Collect log messages and contact technical support personnel.
3. End.

Translation

简体中文

Download

Updated: 2019-04-20

Document ID: EDOC1100039602

Downloads: 133

Average rating:

This Document Applies to these Products