NQA/4/TEST_FAILED
Message
NQA/4/TEST_FAILED: NQA entry test failed. (OwnerIndex=[OwnerIndex], TestName=[TestName], TargetAddressType=[TargetAddressType], TargetAddress=[TargetAddress], OperStatus=[OperStatus], Index=[Index], HopIndex=[HopIndex], AddressType=[AddressType], Address=[Address], CompletionTimeMin=[CompletionTimeMin], CompletionTimeMax=[CompletionTimeMax], SumCompletionTime=[SumCompletionTime], ProbeResponses=[ProbeResponses], SentProbes=[SentProbes], SumCompletionTime2Low=[SumCompletionTime2Low], SumCompletionTime2High=[SumCompletionTime2High], LastGoodProbe=[LastGoodProbe], LastGoodPath=[LastGoodPath])
Description
The number of continuous NQA test failures reached the threshold.
The default threshold is 1, indicating that each time an NQA test fails, the log message is displayed.
Parameters
Parameter Name | Parameter Meaning |
---|---|
OwnerIndex |
Indicates the administrator of an NQA test instance. |
TestName |
Indicates the name of an NQA test instance. |
TargetAddressType |
Indicates the type of the destination address. |
TargetAddress |
Indicates the destination address. |
OperStatus |
Indicates the status of an NQA test instance. |
Index |
Indicates the index of the result table. |
HopIndex |
Indicates the hop index. |
AddressType |
Indicates the type of the source address. |
Address |
Indicates the source address. |
CompletionTimeMin |
Indicates the minimum RTT. |
Possible Causes
Cause 1:
The destination address does not exist and the route is unreachable.
Cause 2:
The destination address exists, but the route is unreachable.
Cause 3:
The network delay is great, causing the RTT of the packet to be longer than the set timeout period.
Procedure
- Run the display this command in the NQA test instance view to check whether the destination address is correctly configured. If the destination address configuration
is correct, go to Step 2. If the destination address is incorrect, run the destination-address command in the NQA test instance view to change the configuration. Then, perform
the test instance again to check whether the test is successful.
- If the test is successful, go to Step 5.
- If the test fails, go to Step 2.
- Run the ping command in the NQA test instance view to check whether the route is reachable. If the route is reachable, go to Step 3. If the destination address is correct but
the route is unreachable, run the display ip routing-table command to check the routing table and rectify the routing fault. Then, perform the test instance again to
check whether the test is successful.
- If the test is successful, go to Step 5.
- If the test fails, go to Step 3.
- Run the timeout time command to change the timeout period according to the actual network condition. The value of time ranges from 1 to
60, in seconds. The default value 3 is recommended. You can run the display this command in the NQA test instance view to check the current timeout period. Then, perform the test
instance again to check whether the test is successful.
- If the test is successful, go to Step 5.
- If the test fails, go to Step 4.
- Contact technical support personnel.
- End.