No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STACKMNG/1/hwStackLogicStackPortLinkErr_active

STACKMNG/1/hwStackLogicStackPortLinkErr_active

Message

STACKMNG/1/hwStackLogicStackPortLinkErr_active: The interface Stack-Port was linked invalidly. (hwStackLocalIfName=[hwStackLocalIfName], hwStackPeerIfName=[hwStackPeerIfName], Reason=[Reason])

Description

Physical member ports of the stack port were connected incorrectly.

Parameters

Parameter Name Parameter Meaning

hwStackLocalIfName

Indicates the name of the local stack port.

hwStackPeerIfName

Indicates the name of the peer stack port.

Reason

Indicates a possible cause.

Possible Causes

  • Cable connection of physical member ports caused a loop.
  • Physical member ports of a local stack port connected to those of two stack ports on the remote device.
  • Physical member ports of a local stack port connected to those of stack ports on different remote devices.
  • The member port of Stack-Port is connected to a common service port.

Procedure

  1. Run the display interface brief command to enter the stack port view, and check whether physical ports of the same stack port are connected.

    • If so, disconnect the ports.
    • If not, go to step 2.

  2. Check whether physical ports of the stack port are connected to a different device.

    • If so, check the protocol status of these ports. Remove the cables that connect the ports whose physical status is Up but protocol status is Down.
    • If not, go to step 3.

  3. Check whether any physical port of the same stack port is connected to another stack port on the same device.

    • If so, run the display stack topology command to check the stack ID of the device that the stack port is connected to. Remove the cables that connect the ports to another device.
    • If not, go to step 4.

  4. Check whether the physical member ports are connected to common service ports.

    • If so, remove the incorrectly connected links or change the ports on both ends of the links to the same mode (stack or common service port mode).
    • If not, go to step 5.

  5. Collect traps, logs, and configurations, and contact technical support personnel.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 126084

Downloads: 90

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next