Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ISIS/3/ISIS_DATABASE_OVERLOAD
Message
ISIS/3/ISIS_DATABASE_OVERLOAD: The overload state of IS-IS LSDB changed. (isisSysInstance=[isisSysInstance], isisSysLevelIndex=[isisSysLevelIndex], isisSysLevelOverloadState=[isisSysLevelOverloadState])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
[isisSysInstance] |
ID of an IS-IS process. |
[isisSysLevelIndex] |
IS-IS level |
[isisSysLevelOverloadState] |
Overload state |
Possible Causes
Cause 1: The set-overload or undo set-overload command was run in the IS-IS view.
Cause 2: The IS-IS process entered the Overload state and then exited from it.
Cause 3: Failed to apply for memory in the case of memory shortage, causing a system crash.
Procedure
- Run the display this command in the IS-IS view to check
whether the set-overload or undo
set-overload command has been configured in the process.
If so, go to Step 5. This log message is informational only, and no action is required.
If not, go to Step 2.
- Run the display memory command to check whether the memory
usage of the has reached the threshold.
If so, go to Step 3.
If not, go to Step 4.
- Obtain user logs and diagnosis logs, and then go to Step 4.
- Contact technical support personnel technical support personnel.
- End.
Previous
