RM/4/hwPublicIpv6PrefixThresholdExceed_active
Message
RM/4/hwPublicIpv6PrefixThresholdExceed_active:The number of public IPv6 prefixes exceeded the threshold. (PrefixCount=[hwCurIpv6PrefixNum], Threshold=[hwIpv6PrefixLimitValue])
Description
The number of IPv6 public route prefixes exceeded the value calculated using the formula (Maximum number x Threshold/100).
Parameters
Parameter Name | Parameter Meaning |
---|---|
PrefixCount |
Number of IPv6 public route prefixes in the routing table |
Threshold |
Threshold of the number of IPv6 public route prefixes |
Possible Causes
Cause 1:
A large number of IPv6 routes were added to the routing table.
Cause 2:
The threshold of the number of IPv6 public route prefixes was decreased.
Procedure
- Run the display ipv6 routing-table statistics command to check the total number of IPv6 public route prefixes and the number of routes of each routing protocol that are added to the IPv6 routing table. Then, run the display ipv6 routing-table limit command to check whether the number of IPv6 public route prefixes exceeds the value calculated using the formula (Maximum number x Threshold/100).
- Delete unneeded IPv6 public routes or run the ipv6 prefix-limit number { alert-percent [ route-unchanged ] | simply-alert } command to increase alert-percent. Then, check whether the alarm persists.
- Collect trap, log, and configuration information, and contact technical support personnel technical support personnel.
- End.