Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DEVM/3/hwLocalFaultAlarm_active
Message
DEVM/3/hwLocalFaultAlarm_active: The local fault alarm has occurred. (IfIndex=[hwPhysicalPortIfIndex], IfName=[hwPhysicalPortName])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
hwPhysicalPortIfIndex |
Physical interface index. |
hwPhysicalPortName |
Physical interface name. |
Possible Causes
The local device reported this trap when a fault occurred on the link from the remote interface to the local interface, for example, the receive optical fiber was disconnected, the card where the local interface resided failed, or an optical module was abnormal.
Procedure
- Check whether the transmit optical fiber fails.
- If so, replace the optical fiber.
- If not, go to step 2.
- Check whether the optical module on the local
or remote interface fails.
- If so, replace the optical module.
- If not, go to step 3.
- Check whether a card on the local or remote
device fails.
- If so, replace the card.
- If not, go to step 4.
- Collect alarm, log, and configuration information, and contact technical support personnel.
Previous
