No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPF/3/OSPF_IF_CONFIG_ERROR

OSPF/3/OSPF_IF_CONFIG_ERROR

Message

OSPF/3/OSPF_IF_CONFIG_ERROR: A packet is received on the non-virtual interface from a router whose configuration conflicts with the local configuration. (RouterId=[RouterId], IfIpAddress=[IfIpAddress], AddressLessIf=[AddressLessIf], PacketSrc=[PacketSrc], ConfigErrorType=[ConfigErrorType], PacketType=[PacketType])

Description

The configurations on the two interfaces for establishing an OSPF neighbor relationship were inconsistent with each other. The possible cause is that the hello, dead, or poll timer on one end was inconsistent with that on the peer end, or the interfaces were not configured on one area.

Parameters

Parameter Name Parameter Meaning

[RouterId]

ID of the local router

[IfIpAddress]

IP address of the non-virtual interface

[AddressLessIf]

Interface index

[PacketSrc]

Source IP address of the packet

[ConfigErrorType]

Error type

[PacketType]

Packet type ID

Possible Causes

Cause 1: Interface parameters configured on the two interfaces for establishing the OSPF neighbor relationship were inconsistent.

Cause 2. The link-layer protocol changed.

Procedure

  1. Run the display ospf interface command to check whether the configurations on the two interfaces are consistent.

    • If the configurations on the two interfaces are consistent, go to Step 3.

    • If the configurations on the two interfaces are inconsistent, go to Step 2.

  2. Do as follows based on the networking:

    • If the networking allows you to modify the configurations on the two ends to be consistent, go to Step 3.

    • If the networking does not allow you to modify the configurations on the two ends to be consistent, go to Step 4.

  3. Modify the parameters of the hello, dead, and poll timers on one end to be consistent with that on the other end. Then, check whether the alarm is cleared.

    • If the alarm is cleared, go to Step 5.
    • If the alarm is not cleared, go to Step 4.

  4. Contact technical support personnel technical support personnel.
  5. End.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 119609

Downloads: 89

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next