CLKM/4/hwClockSourceSwitch
Message
CLKM/4/hwClockSourceSwitch: Clock source switch notification.(hwClockChassisId = [hwClockChassisId], hwClockPllId = [hwClockPllId], hwClockLastSourceName = [hwClockLastSourceName],hwClockCurSourceName = [hwClockCurSourceName], hwClockSrcSelChassisIndex = [hwClockSrcSelChassisIndex], hwClockSrcSelType = [hwClockSrcSelType],hwClockSrcSelMode = [hwClockSrcSelMode])
Parameters
Parameter Name | Parameter Meaning |
---|---|
hwClockSrcSelChassisIndex | Index of the chassis where the clock source resides. |
hwClockSrcSelType | Clock source type:
|
hwClockChassisId | ID of the chassis where the clock source resides. |
hwClockPllId | Clock source type ID. |
hwClockLastSourceName | Last clock source name. |
hwClockCurSourceName | Current clock source name. |
hwClockSourceSelMode | Clock source selection mode:
|
Possible Causes
1: Attributes of a clock device on the network were changed, which caused the switchover of the master clock.
2: An associated link failed or an associated interface became Down, which caused the switchover of the master clock.
3: The clock source was manually switched in manual or forcible clock source selection.
Procedure
- Run the display clock source command to check the operating mode of the clock source.
If the operating mode is free, the clock source is in free state. Then, go to step 6.
If the operating mode is hold, the clock source is in hold state. Then, go to step 6.
If the operating mode is normal, go to step 2.
- Run the display clock config command to check the clock source selection mode.
If the clock source selection mode is manual or forcible, the clock source is switched forcibly. Then, go to step 6.
If the clock source selection mode is automatic, go to step 3.
- Run the display clock source command to check whether the clock source is in normal state.
If so, go to step 4.
If not, go to step 5.
- Run the display clock source command
to check whether the attributes of the clock source are changed.
If so, go to step 6.
If not, go to step 5.
- Collect alarm information, log information, and configuration of the device, and contact technical support.
- End.