No relevant resource is found in the selected language.
MENU
Support Documentation
Log Reference
CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MSTP/4/TC_GUARDED

MSTP/4/TC_GUARDED

Message

MSTP/4/TC_GUARDED:With the TC protection enabled, if TC BPDUs were received after the number of TC BPDUs received by an instance exceeded the threshold, these TC BPDUs were processed after the TC protection time expires. (InstanceID=[InstanceID],bridgePriority=[bridgePriority])

Description

If the number of TC BPDUs received by the MSTP process instance exceeds the threshold, any new TC BPDU will be processed after the TC protection time expires.

Parameters

Parameter Name Parameter Meaning
InstanceID Indicates the ID of an MSTP process.
bridgePriority Indicates the bridge priority.

Possible Causes

The number of TC messages received by an MSTP process in a specified period exceeded the threshold.

Procedure

  • The number of TC messages received by an MSTP process in a specified period exceeded the threshold.
    1. Check whether the network topology flapping occurs.

      • If the network topology flapping occurs, go to Step 3.
      • If the network topology flapping does not occur, go to Step 2.

    2. Run the display stp [ process process-id ] [ instance instance-id ] [ interface interface-type interface-number ] [ brief ] command to check whether the number of TC BPDUs exceeds the set threshold on the interface.

      • If the number of TC BPDUs exceeds the set threshold on the interface, go to Step 4.
      • If the number of TC BPDUs does not exceed the set threshold on the interface, go to Step 7.

    3. Locate the cause of the network topology flapping and rectify the fault. Then, check whether the alarm is cleared. If the alarm persists, go to Step 2.
    4. Run the stp tc-protection threshold threshold command in the MSTP process view to reset the maximum number of TC BPDUs that the MSTP process can process. Then, check whether the alarm is cleared. If the alarm persists, go to Step 5.
    5. Check whether the malicious attack exists.

      • If the malicious attack exists, go to Step 6.
      • If the malicious attack does not exist, go to Step 7.

    6. Locate the attack source and remove the attack. Then, check whether the alarm is cleared. If the alarm persists, go to Step 7.
    7. Collect trap, log, and configuration information, and contact technical support personnel.
Translation
简体中文
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 297952

Downloads: 132

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next
Enterprise APP

Copyright © 2021 Huawei Technologies Co., Ltd. All rights reserved.

You are going to visit :