Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DEVM/4/hwIfMonitorOutputRateRising_active
Message
DEVM/4/hwIfMonitorOutputRateRising_active: Interface output flow bandwidth usage exceeded the trap threshold. (Interface=[IfIndex], BandWidthUsage=[hwIfMonitorOutputRatePercentage], TrapThreshold=[hwIfMonitorOutputRateThreshold], InterfaceName=[InterfaceName])
Description
The percentage of the rate of outgoing traffic to the total bandwidth on an interface exceeded the threshold.
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
Interface |
Specifies an interface index. |
BandWidthUsage |
Indicates statistics on outgoing traffic. |
TrapThreshold |
Specifies an alarm threshold for outgoing traffic. |
InterfaceName |
Specifies an interface name. |
Possible Causes
The percentage of the rate of outgoing traffic to the total bandwidth on an interface exceeded the threshold.
Procedure
- Run the display this interface command in the interface view to check whether the alarm threshold
is set too small. The threshold range is specified by users according
to service requirements.
- If so, go to step 2.
- If not, go to step 3.
- Run the trap-threshold output-rate bandwidth-in-use command in the
interface view to set the alarm threshold to a larger value. Check
whether the trap is cleared.
- If so, no action is required.
- If not, go to step 3.
- Collect traps, logs, and configurations, and contact technical support personnel.
Previous
