Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STACKMNG/4/STACK_MEMPORT_LINK_DOWN
Message
STACKMNG/4/STACK_MEMPORT_LINK_DOWN: The stack member port's link state is down. (hwStackLocalIfName=[hwStackLocalIfName])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| hwStackLocalIfName | Indicates the name of the local interface. |
Possible Causes
Cause 1: Physical member interfaces of the stack interface became Down.
Cause 2: Physical member interfaces of the stack interface were shut down.
Cause 3. The stack link was faulty.
Procedure
- Check the connection and validity of stack cables. Run
the display interface
brief command to check the physical status and protocol
status of the stack interface.
- If the physical status of an interface is Down, check whether the cable connected to the interface is loosened or removed.
- If the physical status of the interface is Up, go to step 2.
- Check whether the shutdown command was executed
on the interface. Run the interface interface-type interface-number command
to enter the stack interface view, and run the display this command to check
whether the shutdown configuration exists.
- If so, run the undo shutdown command.
- If not, go to step 3.
- Collect traps, logs, and configurations, and contact technical support personnel.
Previous
