No relevant resource is found in the selected language.
MENU
Support Documentation
CloudEngine 8800, 7800, 6800, and 5800 V200R005C00 Log Reference

This document provides the explanations, causes, and recommended actions of logs on the product.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ARP/2/hwEthernetARPMACIPConflict_active

ARP/2/hwEthernetARPMACIPConflict_active

Message

ARP/2/hwEthernetARPMACIPConflict_active: MAC and IP address conflict. (Conflict interface=[LogicIfName], Conflict MAC address=[ConflictMAC], Conflict IP address=[ConflictIP], Received packet's destination MAC address=[DstMAC], Received packet's destination IP address=[DstIP], Received packet's VLAN=[Vlan], Received packet's CE-VLAN=[Cevlan], Input interface=[PhyIfName])

Description

The source IP and MAC addresses of ARP packets received by the interface were the same as those of the interface.

Parameters

Parameter Name Parameter Meaning

Conflict interface

Name of the conflict interface where the conflict is detected

Conflict MAC address

Source MAC addresses of the received ARP packets

Conflict IP address

Source IP addresses of the received ARP packets

Received packet's destination MAC address

Destination MAC addresses of the received ARP packets

Received packet's destination IP address

Destination IP addresses of the received ARP packets

Received packet's VLAN

Outer vlan tag of the received ARP packets

Received packet's CE-VLAN

Inner vlan tag of the received ARP packets

Input interface

Interface that receives ARP packets

Possible Causes

The source IP and MAC addresses of ARP packets received by the interface were the same as those of the interface.

Procedure

  • The source IP and MAC addresses of ARP packets received by the interface were the same as those of the interface.
    1. Check the network topology to determine whether there are loops on the network.

      • If a loop is detected go to Step 2.
      • If no loop is detected, go to Step 3.

    2. Remove loops and check whether the log is cleared.

      • If the log is cleared, go to Step 4.
      • If the log persists, go to Step 3.

    3. Collect log information and configuration information, and then contact technical support personnel.
    4. End.
Translation
简体中文
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 302467

Downloads: 132

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next
Enterprise APP

Copyright © 2021 Huawei Technologies Co., Ltd. All rights reserved.

You are going to visit :