Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VRRP/4/vrrpTrapNewMaster
Message
VRRP/4/vrrpTrapNewMaster: The VRRP status changed to master. (ifIndex=[ifIndex], VrId=[VrId], MasterIPAddress=[MasterIPAddress], sysName=[sysName], ifName=[ifName], ChangeReason=[ChangeReason])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| ifIndex | Index of the interface where VRRP is configured |
| VrId | VRID of the VRRP backup group |
| MasterIPAddress | IP address of the master device in the VRRP backup group |
| sysName | System name |
| ifName | Name of the interface where VRRP is configured |
| ChangeReason | VRRP status change reason |
Possible Causes
The status of a router was changed to master.
- VRRP negotiation of the master device timed out due to a network fault.
- The priority of the device in the VRRP backup group was changed using the vrrp vrid virtual-router-id priority priority-value command.
- The virtual IP address of the VRRP backup group was changed using the vrrp vrid virtual-router-id [ virtual-ip virtual-address ] command.
- An mVRRP backup group switchover occurred.
Previous
