OSPF/2/ospfImptNssaLsaMaxExceed_active
Message
OSPF/2/ospfImptNssaLsaMaxExceed_active: The number of NSSA LSAs generated when an OSPF process imports external routes exceeds the configured maximum number.(hwOspfv2ProcessIdIndex=[hwOspfv2ProcessIdIndex], hwOspfv2AreaId=[hwOspfv2AreaId], hwOspfv2MaxLimit=[hwOspfv2MaxLimit])
Description
The number of NSSA LSAs generated when an OSPF process imported external routes reached or exceeded the maximum number allowed.
Parameters
Parameter Name | Parameter Meaning |
---|---|
hwOspfv2ProcessIdIndex |
Index of an OSPF area ID |
hwOspfv2AreaId |
OSPF area ID |
hwOspfv2MaxLimit |
Maximum number of NSSA LSAs allowed |
Possible Causes
The number of NSSA LSAs generated when an OSPF process imported external routes reached or exceeded the maximum number allowed.
Procedure
- Run the display ospf brief command to check whether
the number of NSSA LSAs generated when an OSPF process imports external
routes reaches or exceeds the maximum number allowed.
If the number reaches or exceeds the maximum number allowed, this trap message is informational only and no action is required.
If the number has not reached or exceeded the maximum number allowed, go to Step 2.
NOTE:
Check the overload status based on the value of the Current status field in the display ospf brief command output.- Normal: The number of LSAs generated when an OSPF process imports external routes is less than or equal to the lower alarm threshold (in percentage) multiplied by the maximum number allowed.
- Approach limit: The number of LSAs generated when an OSPF process imports external routes is approaching (reaching or exceeding 90% of) the upper alarm threshold.
- Exceed limit: The number of LSAs generated when an OSPF process imports external routes has reached or exceeded the maximum number allowed.
- Perform the following operations as required:
- If a change in the limit on the number of NSSA LSAs is allowed, run the import-route limit limit-number [ threshold-alarm { upper-limit upper-limit-value | lower-limit lower-limit-value } * ] command to change the limit.
- If a change in the limit on the number of NSSA LSAs is not allowed, go to Step 3.
- contact technical support personnel.
- End.