No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PIM/2/PIM_ROUTE_EXCEED_active

PIM/2/PIM_ROUTE_EXCEED_active

Message

PIM/2/PIM_ROUTE_EXCEED_active: The number of existed routing entries exceeded the global upper limit.(LimitType=[LimitType], AddressFamily=[AddressFamily], CurrentCount=[CurrentCount], LimitCount=[LimitCount],SrcAddr=[SrcAddr], GrpAddr=[GrpAddr], InstanceName=[InstanceName])

Description

The number of created PIM entries on the device reached the specified limit.

Parameters

Parameter Name Parameter Meaning

LimitType

Type of entry for which an entry number limit takes effect, which is one of the followings:
  • PIM-SM (*, G) entry
  • PIM-SM (S, G) entry
  • PIM-DM (*, G) entry
  • PIM-DM (S, G) entry
  • BIDIR-PIM (*, G) entry

AddressFamily

Address family

CurrentCount

Number of created PIM entries on the device

LimitCount

Limit on the number of PIM entries on the device

SrcAddr

Multicast source address

GrpAddr

Multicast group address

InstanceName

Instance of which the number of created PIM entries on the device reaches the specified limit

Possible Causes

New entries were added, or the limit on the number of PIM entries on the device was changed to a smaller value.

Procedure

  1. Run the display multicast global statistics command to check whether the number limit is low.

    • If the limit is low, go to Step 2.

    • If the limit is not low, go to Step 3.

  2. Run the multicast global limit command to set a proper limit. Then, check whether the alarm is cleared.

    • If the alarm is cleared, go to Step 4.

    • If the alarm persists, go to Step 3.

  3. Collect log information and configuration information, and then contact technical support personnel.
  4. End.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 133032

Downloads: 90

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next