Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MPLS_LSPM/3/hwMplsLspThresholdExceed_active
Message
MPLS_LSPM/3/hwMplsLspThresholdExceed_active: The lsp count exceeds the threshold. (hwMplsLspProtocol=[LspProtocol], hwMplsLspCurrentCount=[LspCurrentCount], hwMplsLspThreshold=[LspThreshold], hwMplsLspTotalCount=[LspTotalCount])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
hwMplsLspProtocol |
LSP protocol type |
hwMplsLspCurrentCount |
Number of the current LSPs |
hwMplsLspThreshold |
Upper threshold of LSPs |
hwMplsLspTotalCount |
Upper limit of supported hwMplsLspProtocol LSPs |
Procedure
- Run the display
mpls lsp command to check whether unwanted hwMplsLspProtocol
LSPs exist on the device.
- If no unwanted LSPs exist, go to Step 3.
- If unwanted LSPs exist, go to Step 2.
- Use methods, such as modifying a policy for establishing
LSPs, to suppress the establishment of unwanted LSPs. Then, check
whether the alarm is cleared.
- If so, go to Step 4.
- If not, go to Step 3.
- Collect log information and configuration information, and then contact technical support personnel..
- End.
Previous
