OSPF/3/ospfImptLsaThresholdExceed_active
Message
OSPF/3/ospfImptLsaThresholdExceed_active: The number of AS-external LSAs generated when an OSPF process imports external routes exceeds the configured alarm upper threshold.(hwOspfv2ProcessIdIndex=[hwOspfv2ProcessIdIndex], hwOspfv2Threshold=[hwOspfv2Threshold])
Description
The number of ASE LSAs generated when an OSPF process imported external routes exceeded the upper alarm threshold (in percentage) multiplied by the maximum number allowed.
Parameters
Parameter Name | Parameter Meaning |
---|---|
hwOspfv2ProcessIdIndex |
ID of an OSPF process |
hwOspfv2Threshold |
Upper alarm threshold of ASE LSAs |
Possible Causes
The number of ASE LSAs generated when an OSPF process imported external routes exceeded the upper alarm threshold (in percentage) multiplied by the maximum number allowed.
Procedure
- Run the display ospf brief command to check whether
the number of ASE LSAs generated when an OSPF process imports external
routes exceeds the upper alarm threshold (in percentage) multiplied
by the maximum number allowed.
If the number exceeds the upper alarm threshold (in percentage) multiplied by the maximum number allowed, this trap message is informational only and no action is required.
If the number has not exceeded the upper alarm threshold (in percentage) multiplied by the maximum number allowed, go to Step 2.
NOTE:
Check the overload status based on the value of the Current status field in the display ospf brief command output.- Normal: The number of LSAs generated when an OSPF process imports external routes is less than or equal to the lower alarm threshold (in percentage) multiplied by the maximum number allowed.
- Approach limit: The number of LSAs generated when an OSPF process imports external routes is approaching (reaching or exceeding 90% of) the upper alarm threshold.
- Exceed limit: The number of LSAs generated when an OSPF process imports external routes has reached or exceeded the maximum number allowed.
- Perform the following operations as required:
- If a change in the limit on the number of ASE LSAs is allowed, run the import-route limit limit-number [ threshold-alarm { upper-limit upper-limit-value | lower-limit lower-limit-value } * ] command to change the limit.
- If a change in the limit on the number of ASE LSAs is not allowed, go to Step 3.
- contact technical support personnel.
- End.