No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
EOAM-1AG/3/UNEXPECTEDPERIOD_active

EOAM-1AG/3/UNEXPECTEDPERIOD_active

Message

EOAM-1AG/3/UNEXPECTEDPERIOD_active:MEP received a CCM with unexpected period. (MdIndex=[MdIndex], MaIndex=[MaIndex], MdName=[MdName], MaName=[MaName], MepId=[MepId], RmepId=[RmepId])

Description

The CCM interval carried in a CCM sent by the RMEP was different from that specified on the MEP.

Parameters

Parameter Name Parameter Meaning
MdIndex Index of an MD table
MaIndex Index of an MA table
MdName Name of an MD
MaName Name of an MA
MepId ID of a MEP
RmepId ID of an RMEP

Possible Causes

The CCM interval carried in a CCM sent by the RMEP was different from that specified on the MEP in the scenario where the MEP and RMEP had the same MD level and MA ID, and the MEP was enabled to receive CCMs carrying the specified RMEP ID.

Procedure

  • Run the display cfm ma [ md md-name [ ma ma-name ] ] command to view the value of the Interval field on the MEP and RMEP. Check whether the intervals configured on the MEP and RMEP are the same.

    • If they are the same, go to Step 3.

    • If they are different, go to Step 2.

  • Perform the following steps on the MEP:
    1. Run the cfm md md-name command to enter the MD view.
    2. Run the display this command. Check whether the mep ccm-send enable command has been run to enable the MEP to send CCMs and the remote-mep ccm-receive enable command has been run to enable the MEP to receive CCMs.
    3. If the mep ccm-send enable command has been run, run the undo mep ccm-send enable command to disable the MEP from sending CCMs.
    4. If the remote-mep ccm-receive enable command has been run, run the undo remote-mep ccm-receive enable command to disable the MEP from receiving CCMs.
    5. Run the ccm-interval interval command to configure the interval between CCMs the same as the interval configured on the RMEP. Then run the remote-mep ccm-receive enable command to enable the MEP to receive CCMs and the mep ccm-send enable command to enable the MEP to send CCMs.
  • Collect configuration, trap messages, and log messages, and then contact technical support personnel.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 122705

Downloads: 90

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next