No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPF/3/OSPF_IF_AUTH_FAILURE

OSPF/3/OSPF_IF_AUTH_FAILURE

Message

OSPF/3/OSPF_IF_AUTH_FAILURE:A packet is received on a non-virtual interface from a router whose authentication key or authentication type conflicts with the local authentication key or authentication type. (RouterId=[RouterId], IfIpAddress=[IfIpAddress], AddressLessIf=[AddressLessIf], PacketSrc=[PacketSrc], ConfigErrorType=[ConfigErrorType], PacketType=[PacketType])

Description

The authentication on the non-virtual interface failed. The possible cause is that the configuration on the non-virtual interface of the peer end conflicted with the configuration of the local end.

Parameters

Parameter Name Parameter Meaning

[RouterId]

ID of the local router

[IfIpAddress]

IP address of the non-virtual interface

[AddressLessIf]

Interface index

[PacketSrc]

Source IP address of the packet

[ConfigErrorType]

Error type

[PacketType]

Packet type ID

Possible Causes

The authentication mode configured on the non-virtual interface was incorrect.

Procedure

  1. Run the display current-configuration command to check whether the authentication configurations on the two ends are consistent.

    • If the authentication configurations are consistent, go to Step 3.

    • If the authentication configurations are inconsistent, go to Step 2.

  2. Do as follows based on the networking:

    • (1) If the networking allows you to modify the configurations of the two ends to be consistent, go to Step 3.
    • (1) If the networking does not allow you to modify the configurations on the two ends to be consistent, go to Step 4.

  3. If the plain text authentication mode is used, modify the authentication passwords on the two ends to be consistent. If the encrypted text authentication mode is used, re-configure the authentication mode on the two ends as required. Then, check whether the trap is cleared.

    • If the alarm is cleared, go to Step 5.
    • If the alarm is not cleared, go to Step 4.

  4. Contact technical support personnel technical support personnel.
  5. End.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 123236

Downloads: 90

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next