Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPF/2/ospfLsdbOverflow_active
Message
OSPF/2/ospfLsdbOverflow_active: The number of AS-external LSAs in the LSDB of an OSPF process reaches the configured maximum number.(hwOspfv2ProcessIdIndex=[hwOspfv2ProcessIdIndex], hwOspfv2MaxLimit=[hwOspfv2MaxLimit])
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
hwOspfv2ProcessIdIndex |
ID of an OSPF process |
hwOspfv2MaxLimit |
Maximum number of external routes supported by the OSPF LSDB |
Procedure
- Run the display ospf brief command. If OSPF
is in LSDB overflow status is displayed in the command output,
the OSPF LSDB in the current OSPF process is overloaded. If OSPF
LSDB is approaching overflow limit is displayed in the command
output, the number of external routes in the OSPF LSDB has reached
or exceeded 90% of the maximum number.
If the OSPF LSDB is overloaded, go to Step 2.
If the OSPF LSDB is not overloaded, this trap message is informational only and no action is required.
- Perform the following operations as required:
- If a change in the maximum number is allowed, run the lsdb-overflow-limit number command to increase it.
- If a change in the maximum number is not allowed, go to Step 3.
- contact technical support personnel.
- End.
Previous
