No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPFV3/3/OSPFV3_TRAP_IF_CONFIG_ERR

OSPFV3/3/OSPFV3_TRAP_IF_CONFIG_ERR

Message

OSPFV3/3/OSPFV3_TRAP_IF_CONFIG_ERR: A packet is received on the non-virtual interface from a router whose configuration conflicts with the local configuration. (RouterId=[RouterId], IfIndex=[IfIndex], IfInstId=[IfInstId], IfState=[IfState], PacketSrc=[PacketSrc], ConfigErrorType=[ConfigErrorType], PacketType=[PacketType])

Description

A packet received from the non-virtual interface of an OSPFv3 router indicates that the configurations on the interface conflicted with that on the local non-virtual interface. The possible cause is that the hello, dead, or poll timer on one interface was inconsistent with that on the other one, or the two interfaces were not configured on one area.

Parameters

Parameter Name Parameter Meaning

RouterId

Router ID of the local device.

IfIndex

Index of the local router interface.

IfInstId

Instance ID of the local router.

IfState

Interface status.

PacketSrc

Source IP address of the packet.

ConfigErrorType

Error type.

PacketType

Packet type.

Possible Causes

Cause 1: Parameters configured on the two ends were inconsistent.

Cause 2: The link-layer protocol changed.

Procedure

  1. Run the display ospfv3 interface command to check whether the configurations on the two ends are consistent.

    • If the configurations on the two ends are consistent, go to Step 3.

    • If the configurations on the two ends are inconsistent, go to Step 2.

  2. Do as follows according to the networking:

    • If the networking allows users to modify the configurations on the two ends to be consistent. Modify the parameters of the hello, dead, and poll timers on one end to be consistent with that on the other end based on the Configuration Guide. Then, check whether the alarm is cleared.
      • If the alarm is cleared, go to Step 4.
      • If the alarm is not cleared, go to Step 3.
    • If the networking does not allow users to modify the configurations on the two ends to be consistent, go to Step 4.

  3. Contact technical support personnel technical support personnel.
  4. End.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100039602

Views: 132972

Downloads: 90

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next